Your Quote List
USA: (888) 883-5274
INTL: +1 (847) 940-9305

Customers who are looking to run a part multiple times without using a key board may choose to wire a switch into their FlashCut CNC Signal Generator’s Input Lines. This switch can be used to trigger the start of a program as long as the following occur:

The switch’s function must be defined as a ‘Start’ Input Line in the Configuration > I/O > Input Lines Configuration Panel.
The G-Code file of the part meant to be run repeatedly must be loaded.
An M30 command, which resets a G-Code file, must be added to the end of the G-Code file that is meant to be run repeatedly.